Expert advice
Own bonsai production
Low prices through direct import
Immediate shipping throughout Europe
Right of return and exchange

Bonsai cover mesh

Bonsai pots usually have holes for drainage. These drainage holes are covered with cover grids or cover nets before repotting a bonsai so that no bonsai soil trickles out later. In addition, these cover nets prevent pests from penetrating the pot.

Select the appropriate size and packaging for the covering grids here. The cover nets can be cut to the right size with an old bonsai scissors.

Other useful items for attaching the cover grids include: Bonsai wire to secure the grids over the drainage hole and wire cutters to cut the wire into pieces.

Items 1 - 3 of 3

Attaching the cover grids for bonsai pots

Root cells of a bonsai, like all plant cells, need oxygen. A well-drained, coarse-grained bonsai soil and large drainage holes in the bottom of the bonsai pot are important so that enough oxygen comes to the roots.

In the case of large drainage holes, the substrate trickles out of the drainage holes after repotting the bonsai. Therefore these holes are covered with potting mesh (drainage grids). Since they slip easily when potting a bonsai tree, it is important to fix them.

How are they attached ? Very easily. Follow these step by step instructions:

Cut the cover grille

The grille should be slightly larger than the drainage hole in the bonsai pot. It is best to use old bonsai scissors for cutting.

Cut wire

It is sufficient if the fastening wire is approx. 3-4 times as long as the diameter of the drainage hole. 1.5mm aluminum bonsai wire is perfect for this. If the wire is thinner, the grid slips easily. If it is too thick, it is difficult to thread through and bend when attaching the cover net.

Bend wire

The cut piece of wire is bent into a U-shape. The width of the U should match the diameter of the drainage hole.

Fasten the grid

Place the grid in the pot on the hole and push the wire through from the inside to the outside. Then turn the bonsai pot over and bend the wire ends from below until they lie flat on the base of the pot.

If you want to make it particularly beautiful, bend the wire ends a little bit round.

There are no items in the basket.